Home

IBM 5162  -  SETUP Procedure


Motherboard BIOS configuration of the IBM 5162 is referred to by IBM as SETUP.  Some people refer to it as CMOS SETUP.

Some reasons for running the SETUP procedure are:
   • You have changed an option in the 5162 (e.g. add/remove RAM, change video card type, ...)
   • You have replaced a dead/low battery
   • Somehow, the SETUP has become corrupted, and you need to correct that

The IBM way of running the SETUP procedure is to boot the 5162 from the 'Diagnostics for IBM AT and IBM XT Model 286' floppy, however other methods are available.



IMPORTANT:   The following assumes that your IBM 5162's motherboard is fitted with IBM 5162 BIOS ROM's, i.e. not swapped out for non-IBM ones.
If non-IBM BIOS ROM's are fitted, the following may not work (it depends on the particular BIOS).



METHOD 1 - THE IBM WAY: USING THE DIAGNOSTICS FLOPPY

This method requires that you have the 'Diagnostics for IBM AT and IBM XT Model 286' 5.25" floppy.

A procedure for using that floppy to perform SETUP is at here.  The procedure pointed to is actually for the IBM 5170, but the 5162 procedure is similar enough that you will adjust.

In fact, the IBM 5162 and IBM 5170 are so close, that you can use the 'Diagnostics for the IBM Personal Computer AT' floppy intended for the 8 Mhz version of the IBM 5170.  All that you will lose is the ability to set the hard drive type to type 24.

An IBM 5162 supports 1.44M drives.  A limitation of this method is that a 1.44M drive cannot be set.  If you need to achieve that, use either of the two following methods.



METHOD 2 - TYPING CODE INTO BASIC

With this method, you do not need a floppy.
The IBM 5162 will be allowed to boot into BASIC, and then you'll type in some BASIC commands.

Click here for the procedure.



METHOD 3 - USING THE GSETUP PROGRAM

GSETUP.EXE is a 'generic' third-party SETUP program, suitable for most early AT-class computers.  It is suitable for the IBM 5162.

On the IBM 5162, if required, you can run GSETUP by temporarily connecting a 1.44M diskette drive in place of one presently acting as A:, and then booting from a 1.44M boot diskette that contains GSETUP.EXE.

Click here.