===================================================================== Last Revised AST RESEARCH, INC. SOFTWARE BULLETIN # 0275 06/25/97 ===================================================================== TITLE: Bravo LC 5100/5133/5166 BIOS, v1.04 FILENAME(S) / PART NUMBER(S) / DESCRIPTION(S): 05574035.EXE / 905574-035 Bravo LC 5100/5133/5166 BIOS, v1.04 SUMMARY File 05574035.EXE contains version 1.04, disk 1 of 1, of the Bravo LC 5100/5133/5166 system BIOS. This update applies to the following systems: 501958, 501959, 501961, 501979, and 503031. RESOLUTIONS Version 1.04 resolves the following issues: Fixed the CD-ROM detecting issue after CMOS is corrupted. Fixed the resource allocation issue between PCI and onboard ISA devices. Fixed the issue of detecting Plug-and-Play printers in ECP mode. Fixed the Western Digital Phoenix drivers issue where the drive's firmware did not handle the SET MULITPLE command correctly. Fixed the issue with video cards that failed at POST 63. Fixed the 3COM card issue which showed memory failure caused by the bus mastering continuing at warm boot. ENHANCEMENTS Release 1.04 contained the following enhancement: Added support for the year 2000 in the BIOS function call. PREVIOUS RELEASE(S) ========================================================= Release 1.03 contained the following resolutions and enhancements: The system hung when the Shuttle Pocket Adapter installation program tried to sense the parallel port if the parallel port was set to Enhanced mode in Setup. The BIOS reported POST error 12.31 if both floppy drive types were set to None and the onboard floppy adapter was set to Add-in, but an add-in floppy controller was not installed. The system was unable to boot from floppy if the SMC network card (with remote boot ROM) was configured in the system. The system experienced a spin-up timeout problem with Western Digital's 2.1GB hard drive, model number WD32100. Improved the IDE drive detection logic. Added a parity field in BIOS Setup if parity was ENABLED. Supported L2 cache larger than 256KB. Allowed the system to boot when a parity error was found during memory test. Added suspend mode support in Advanced Power Management. ====================================================== Release 1.02 contained the following resolutions and enhancements: Fixed the year 2000 issue. The date was not reported correctly when it changed from year 1999 to year 2000. Fixed the issue where the number of heads of IDE drives was not reported correctly in SETUP on WD 32500. Added system BIOS part number field in SETUP. Previous releases also contained the following issue resolutions and enhancements: Fixed the issue reporting CPU speed in CommandCenter. NOTES N/A For information on installing this update, please view the README.TXT file that accompanies the update. You can download this file from the following services: AST WWW Site: http://www.ast.com AST On-Line! BBS*: See IB0001.TXT CompuServe: GO: ASTFORUM Prodigy: JUMP: ASTSUPPORT * Refer to IB0001.TXT for a list of AST's international BBS numbers. To decompress this file, create a temporary directory on your hard drive, copy the downloaded file to that directory, and run the file. TAN 003800PS --------------------------------------------------------------------- The information in this data sheet is subject to change without notice. AST Research, Inc. shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. This material contains information protected by copyright. No part of this material may be reproduced in any form without prior written consent from AST Research, Inc. All rights reserved. --------------------------------------------------------------------- Template Rev 02