=

AST RESEARCH, INC.              TECHNICAL BULLETIN # 0900A             8-9-94

=


                  PREMMIA LX SYSTEM HANGS DURING INSTALLATION OF OS/2 2.1


PROBLEM:        When trying to install OS/2 2.1 on a Premmia LX with a Future
                Domain PCI SCSI HBA the system hangs.

CAUSE:          The existing FD16-700.ADD file is no longer valid.

SYSTEMS
AFFECTED:           AST                                              REVISION
                PART NUMBER            DESCRIPTION                     LEVEL

                501288-XXX      PREMMIA LX PRENTIUM/60                  All

SOLUTION:       Replace the existing FD16-700.ADD file with an updated
                version.  This is done as follows:

                CD-ROM INSTALLATION

                1. Replace the FD16-700.ADD file, dated 4/29/93, on the IBM
                   OS/2 2.1 Setup Diskette #1 with the FD16-700.ADD file,
                   dated 1/10/94 or later.
                   FD16-700.ADD along with README.TXT are contained in
                   PCI_OS2.EXE which can be downloaded from the Future Domain
                   BBS (714-253-0432).

                2. Run the OS/2 2.1 setup from the floppy diskettes.  This
                   will copy the  FD16-700.ADD file  on the OS/2 2.1 CD-ROM to
                   the hard drive using a character-based interface.

                3  Prior to reloading OS/2 2.1, the FD16-700.ADD file which
                   was loaded on the disk must be replaced with the new
                   FD16-700.ADD file.

                4. Reload OS/2 2.1 using the graphical interface.  Following
                   this configuration, the FD16-700.ADD file on the hard disk
                   must be replaced with the new FD16-700.ADD file (copied
                   from the BBS in step 1).  This step is required because the
                   old FD16-700.ADD file is recopied onto the hard disk from
                   the CD-ROM during the graphical configuration stage.

                DISKETTE INSTALLATION

                1. Replace the FD16-700.ADD file, dated 4/29/93, on the IBM
                   OS/2 2.1 Setup Diskette #1 with the FD16-700.ADD file,
                   dated 1/10/94 or later.  This file can be downloaded from
                   the Future Domain BBS (714-253-0432).

                2. Run the normal OS/2 2.1 setup from the floppy diskettes.