=

AST RESEARCH, INC.           TECHNICAL BULLETIN # 1236              6-22-95
=



MANHATTAN G590 WITH 8150 AND 8100 ERROR 12.35


PROBLEM

When one NCR 8150 SCSI controller and one NCR 8100 SCSI controller are 
installed in the Manhattan G590, the system displays the following error 
message at boot: 

"12.35 The computer encountered and error during the autoconfiguration 
process."

The system continues to boot without any other error messages.


CAUSE

The error message is caused by the two different SCSI BIOS configuration 
routines occurring within the system at the same time.  The two controllers 
differ only because the 8100 does not contain an on-board SCSI BIOS, while 
the 8150 does include a SCSI BIOS ROM built onto the board.  In this 
configuration, the 8150 SCSI BIOS loads and is used by both controllers.  
The system BIOS issues the error message to indicate that the computer 
did not configure the 8100 controller.

There is no reduction in functionality or reliability in this configuration. 
The error message does not indicate any condition that will lead to failures 
or problems with the system.


SYSTEMS AFFECTED
AST PART NUMBER AND DESCRIPTION           REVISION
	
501723-XXX      MANHATTAN G590            All Models


SOLUTION

Because the error message will not lead to any problem or reduction in 
functionality, the error message should be ignored.

There are no plans to remove this message from the boot-up sequence of 
systems using the above configuration.