Last Revised
AST RESEARCH, INC.        TECHNICAL BULLETIN # 1756          09/09/97 
 
 
 
TITLE:  Bravo Lockups and Intel Pro 100B       
 
 
ISSUE 
 
   When using the NDIS driver, version 2.22, on a Bravo MS or MS-T 
   system, the unit may lockup or a General Protection Fault Error 
   (GPF) may occur during the Windows 95 shutdown process, or during 
   a system warm boot. These intermittent errors may generally be 
   seen after shutting down or warm-booting the system five to six 
   times.
    
   This issue may affect the following systems: 503246, 503247, 
   503250, 503251, 503320, 503321, 503322, 503323, 503417, and 
   503418 or any system utilizing an Intel Pro 100B network card.    

 
BACKGROUND 
 
   N/A    

 
ACTION 
 
   Upgrade the Windows 95 Intel Pro 100B drivers to version 2.51 or 
   higher. Obtain file 100BDISK.EXE from Intel's web page at 
   www.intel.com. 
   
   For installation instructions, run Setup/README from the command 
   prompt on the Intel Pro 100B driver diskette.    

 
NOTES 
 
   To verify the NDIS driver version, run the Intel Proset utility 
   that is included on the driver diskette.    

 
TAN TPR 2400RK 
 
--------------------------------------------------------------------- 
The information in this data sheet is subject to change without  
notice. AST Research, Inc. shall not be liable for technical or  
editorial errors or omissions contained herein; nor for incidental or  
consequential damages resulting from the furnishing, performance,  
or use of this material. This material contains information protected  
by copyright. No part of this material may be reproduced in any form 
without prior written consent from AST Research, Inc.  
All rights reserved. 
--------------------------------------------------------------------- 
Template Rev 02