TECHNICAL SUPPORT BULLETIN
Number: TSB-0010-C
Date : 87-02-16
Ref. : KM
Page : 1 of 1

EXTERNAL 5.25" FLOPPY DISK DRIVE SETUP.

Important points to remember when connecting a 5.25" external disk drive.

1. Always make sure you have the 18 volt power pack attached to the external drive.

2. Set the drive select switch on the left side of the system
to either "A" or "B". (This will specify whether the external drive will be called "A"or "B".)

3. When hooking up the cable between the system and 5.25" drive
the label on each end of the cable must correspond to the equipment it is being attached to.

4. Power on external disk drive first before powering on system. 

The design of the external 5.25" drive has been changed slightly. 
The disk eject button has been replaced by a "Swing Arm". 
Otherwise the product is still the same.


    DISCLAIMER

Trademarks are registered to their respective companies. Toshiba Canada Ltd. has done its best to ensure the accuracy of this information. Despite every effort to the contrary, errors, omissions, or discrepancies may have occurred in preparation of this document, and Toshiba Canada Ltd. assumes no liability for damages incurred due in part or in whole to such errors.